Autoglym Polar Blast, a pre-wash extraordinaire. Polar Blast offers a touch-free, rich snow foam experience that elevates your car washing session, and paintwork finish.
Polar Blast is safe on all surfaces including ceramic coated vehicles or vehicles that have spray sealants applies like Polar Seal, Aqua Wax or Rapid Ceramic Spray.
Effortlessness Taken to the Max
Our Polar Blast may appear as though you’re covering your car with a blanket of snow. But under the surface, this thick, high-cling foam is gently loosening dirt and heavy soiling, all without damaging your precious paintwork or requiring any physical contact. All to prepare your car for its much-loved Polar Wash.
Concentrated Polar Power
Although you could go stronger, our team of testers recommend you dilute one-part Polar Blast to five-parts water you achieve a foam that works wonders in just three minutes. Which means one bottle will go a long way.
High Foaming Action
Polar Blaster at the ready. To create optimum foam levels, we recommend using our foam gun with your pressure washer to apply Polar Blast. Not only will you get a greater blanket of foam, it activates superior clinging capabilities for a better clean.
pH Neutral Formulated
Safe to use on all areas of your car, this touchless pre-wash offers impressive foam theatre that doesn’t remove previously applied waxes or sealants. Saving you time and money, with effortless car washing after your very first application.
Polar Blast in Winter or on Heavy Soiled Vehicles?
Polar Blast is pH neutral and might struggle with heavy dirt or traffic film, especially in the winter. An APC or Citrus Pre-Wash can help in these cases. Autoglym APC is a handy 1L bottle to keep close by in these conditions.
How to use Autoglym Polar Blast
- Before you start, check that the bodywork and wheels are cool to the touch and out of direct sunlight.
- Polar Blast can be used at various dilutions depending on the density of foam desired. A good starting point is 100ml product to 500ml water in your foaming bottle. Adjust foam gun settings as required to increase or reduce foam.
- Spray Polar Blast onto the vehicle, starting at the bottom, ensuring all exterior surfaces are covered, including glass and wheels.
- Leave Polar Blast time to dwell and loosen dirt for up to 10 minutes, although do not allow it to dry on.
- Finally, rinse thoroughly from the bottom up.